Confirm vise is true to machine and review small basic weldmentReview set up sheet and problem solve any concernsUnderstand basic programming and work with team if concernsRun right angle head programRun all vertical machinesUnderstand basic vacuum tool trainingSet up basic and advanced operations of machine centersUse appropriate machining tools: go/no go gauges, calipers, inside micrometersSet up, operate, and tend to preventative maintenance for CNC equipmentInterpret and work from complex drawings and blue printsIdentify non-conformances during inspection of component parts and properly document such non-conformancesNotify supervisor when work received does not meet the specifications required by previous operatorsResponsible to record an accurate log of job times and specifications for audit reportsMaintain clean equipment/tools and work areaFollow established safety proceduresEducation:High School/GED - required1 year machining certification - preferredExperience:2-6 years of machining experience1+ years of Haas Control – preferred1+ years of Fanuc Bridge Mill Controls - preferredPhysical Demands: The physical demands described below are representatives of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.While performing the duties of this job, the employee is required to:Frequently: sit, grasp/hold, fine manipulation of both handsOccasionally: reach at shoulder, lift/carry, and walkSeldom: stand, reach below shoulder, reach above shoulderPercent of job performed per Hours Worked:0% - 15% Seldom16% - 33% Occasionally34% - 65% Moderate66% - up Frequently